Enerpac WCR-Series Manual de usuario Pagina 1

Instruction SheetWCR4000 Roller CassetteL4021English (GB) Rev. B 09/2013

10ENGLISHFig. O5 Maintenance and troubleshooting5.1 Spanner replacement (Fig M)• Remove drive unit from cassette.• Loosen and remove set screw (1

ENGLISH11• Remove circlips (24) reaction rollers (25) and roller pin (26).• Clean all exposed components with a mild solvent.• Inspect all parts for

• Reverse the procedure to reassemble. When reassembling the drive unit make sure that the piston rod is inserted through the cylinder spigot end. W

ENGLISH136 Technical specifications and torque settings6.1 Capacities and dimensions - Model WCR4000(fig. Q) Spanner size range mm 36 - 80 i

HFG14ENGLISH6.2.2 Imperial system tableSpanner (F) (G) (H) WeightModel inch inch inch lbsW4107CS 1 7/16 1.22 1.18 4.0W4108CS 1 1/2 1.26 1.18 4.7

ENGLISH156.3.1 Metric system pressure/torque table - Model WCR4000Pump pressure (bar) Torque (Nm)69 576124 1.036179 1.495207 1.729234 1.954262 2.1882

16ENGLISH7 Replacement parts and recommended tools7.1 To order replacement parts For replacement parts information, refer to the Enerpac repair par

17NOTES:

18NOTES:

19NOTES:

2

Australia and New ZealandActuant Australia Ltd. Block V Unit 3Regents Park Estate391 Park RoadRegents Park NSW 2143(P.O. Box 261) AustraliaT +61 (0)2

ENGLISH3 Index1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 Safety. . . . . .

2 SafetyBe aware that the operator is fully responsible during the operation of this tool. Enerpac is not responsible for damage or injury caused by m

ENGLISH5- Do not stand in the line of movement of the tool when it is in operation. If the tool separates from the nut or bolt during operation it wi

6ENGLISHFig. A3 Assembly and adjustments3.1 Overview and features (fig. A or B)1 Spanner2 Roller Cassette3A Swivel manifold (standard)3B TSP-Pro Swi

ENGLISH7Fig. F• Swing the reaction roller bracket (8) outward, away from center of tool.3.3 To connect the hoses (fig. F) Make sure all accessories m

Fig. I8ENGLISH4 Operation4.1 Prior to operation- Make sure the nut or bolt to be fastened is clean and free of dust.- Make sure the nut or bolt run

ENGLISH9Fig. K Keep hands and fingers clear of pinch point area between spanner and reaction roller. See Fig J. Keep hands and fingers clear of pinch